Black Budget Roof Tiles » Budget Black Verge (Left)
£5.82 Excludes VAT
Our verge caps can be used to cover the exposed, pitched edge of a roof conversion. This ensures that water does not run under the tiles and finishes the roof off nicely. These verge caps are provided in a basic, un-textured black colour.
Verge caps are available in two types (either left or right), you need to ensure you use the correct type of cap when fitting.
A single verge cap covers 0.94 linear meters, (so if you need 3 meters you should ideally buy 4). This approximately equates to one verge cap required for every three Lightweight Tiles.
Overall Length: 1110mm
Usable surface: 940mm
“ We wanted a covered patio area and discovered the website. The tiles are light and were put up in just a few hours compared with a couple of days for concrete tiles. The infrastructure is a lot lighter and the whole project was completed far quicker than if we had used conventional tiles.
Result, very noticeable reduction in solar heating on sunny days, retains heat better when heated on cool days, and is much quieter, rain and road noise greatly reduced. Had a bit of a struggle with the Ubiflex, found it to be ‘floppier’ than traditional lead, more difficult to feed a long length into slot cut in mortar. Once in place, Ubiflex sealants worked well, and it was easy to mould the flashing to fit the tiles.”
- Richard Pitman , Worcester