×

COVID-19 UPDATE

7/7/20 Our Factory is open, however, lead times are a maximum 28 days until further notice. Our office is operating on reduced hours, so please be patient and use email correspondence where possible.

Thank you for your support and if you have any urgent queries, please contact us on [email protected]

LightWeight Tiles Foam Eaves/Ridge Fillers

Grey Granulated Roof Tiles » LightWeight Tiles Foam Eaves/Ridge Fillers

£4.50  Excludes VAT

Our self-adhesive Foam Eaves/Ridge Filler Pair can be fully utilised on Gable Style Roofs that have an equal Ridge and Eaves length. However, they can partially be used on all other roof shapes as well. One half of the gap fillers can be used underneath the lip of the Ridge Tiles and one half in front of the Bottom Batten... read more

We aim to dispatch this product within 28 days (depending on availability).

All our tiles come with a
25 Year Guarantee

Work out how many tiles you need for your roof conversion

Use Our Calculator

Our self-adhesive Foam Eaves/Ridge Filler Pair can be fully utilised on Gable Style Roofs that have an equal Ridge and Eaves length. However, they can partially be used on all other roof shapes as well. One half of the gap fillers can be used underneath the lip of the Ridge Tiles and one half in front of the Bottom Batten on the Eaves. Please see our installation guidelines for more information.

PLEASE NOTE Both sides of the roof on a Gabled Style roof will need sealing. Therefore, the foam quantities required will be double the length of the ridge. (See the below coverage information)

Due to these strips being profiled to the exact shape of our tiles, they are unsuitable for use on hips (due to the diagonal variations). We therefore recommend using Flexim Roof Putty as a gap filler where the roof has hips. Unfortunately, Flexim Roof Putty is only able to be used in conjunction with our granulated tiles and not the smooth.

The purpose of the Ridge Filler section of the pair, is to seal the gap underneath the ridge tiles. The Eaves Filler section is to be used in front of the bottom batten, to hide the batten and minimise entry of insects, for example.

Eaves and Ridge Foam Filler Pair Dimensions

Length: 1100mm
Width: 23mm
Maximum Depth: 20mm
Coverage: 1090mm

Each strip can be compressed by up to 50%, giving versatility to various roof pitches.

For roofs which do not have an equal ridge and eaves length (All roof shapes other than Gable) please allow enough foam filler pairs for the total length of the Eaves. Then discard any Ridge Sections that aren't required. Unfortunately, we are unable to sell the sections of the pairs individually or provide refunds for any partially used pairs.

find out more about these foam fillers on our blog. Or watch the installation video below.

We wanted a covered patio area and discovered the website. The tiles are light and were put up in just a few hours compared with a couple of days for concrete tiles. The infrastructure is a lot lighter and the whole project was completed far quicker than if we had used conventional tiles.

Result, very noticeable reduction in solar heating on sunny days, retains heat better when heated on cool days, and is much quieter, rain and road noise greatly reduced. Had a bit of a struggle with the Ubiflex, found it to be ‘floppier’ than traditional lead, more difficult to feed a long length into slot cut in mortar. Once in place, Ubiflex sealants worked well, and it was easy to mould the flashing to fit the tiles.

- Richard Pitman , Worcester

Back to Top