Red Budget Roof Tiles » Budget Red Verge (Right)
£7.00 Excludes VAT
Our verge caps can be used to cover the exposed, pitched edge of a roof conversion. This ensures that water does not run under the tiles and finishes the roof off nicely. These verge caps are provided in a basic, un-textured red colour.
Verge caps are available in two types (either left or right), you need to ensure you use the correct type of cap when fitting.
A single verge cap covers 0.94 linear meters, (so if you need 3 meters you should ideally buy 4). This approximately equates to one verge cap required for every three Lightweight Tiles.
Overall Length: 1110mm
Usable surface: 940mm
“ This old building in our garden is known to us as the Ranch House. It is known to be at least 75 years old and may well be more. The roof in particular was falling apart, it was covered in corrugated bitumen sheeting which was well past its used by date. We had two choices; demolish it or renovate it. We decided to renovate but felt that it deserved something better than corrugated sheeting on the roof. This was why we selected Lightweight Tiles after several email exchanges with Laura and Susan plus going to meet Laura at the Renovation Show in Birmingham.
The hard part was completely rebuilding the roof structure as we decided to change the pitch of the roof. Fitting the tiles was easy. Two of us fitted 70 tiles on the long side in 5 hours which included a leisurely lunch and several cups of tea. I fitted the remaining 30 on the other side on my own in about the same time. I have one tip though, it is worth drilling a small pilot hole for each screw, you can then fit the screws much more neatly.
We are very pleased with the transformation, I keep going down the garden to look at it!”
- Bob S , Cheltenham